Some issue with Montreal scenery in PD3 V4

[PierreNantel]

I have some difficulty installing the Montreal scenery in Prepar3D ver 4. I have use the FlyTampa_Montreal_FSX_P3D_14 version and I also followed the instruction for the patch install. When I did the install I also received a error message during the Vistamare installation and it aborted. When I load the scenery in Prepard3d it is called ZYUL and not CYUL, is this normal? Also I do not have the choices to start at any gates, the only option are: active runway or Tower. If I choice active runway the plan starts in a parking lot for from the airport see attach picture.

Plane location in red

flyTampa Montral.jpg (593.62 KiB) Viewed 4101 times

I also include a picture of my Scenery Library.

Library view

Scenery Library.jpg (175.46 KiB) Viewed 4101 times

Can you help?

[george[flytampa]]

Ignore ZYUL. Its needed for the tunnels only.

Going by your shot, the patch hasn't been installed in the correct location. Make sure you copy the patch bgl files to Montreal\scenery & the dds files to Montreal\texture.

[PierreNantel]

Thanks George I was actually loading the ZYUL scenery, I just try loading the CYUL one and it seem to work find. Is it normal that in Prepar3d when I pick the location CYUL, there is not mention of the Fly Tampa

Selecting the location CYUL

Selecting Airport screen.png (69.87 KiB) Viewed 4079 times

But when viewing ZYUL you do see Montreal Tampa.

Viewing ZYUL in the table

Slecting Zyul in Airport screen.jpg (138.18 KiB) Viewed 4079 times

Thanks for the support

Pierre

[george[flytampa]]

looks normal. Hope you like it.