runway level

nandando · Post by **nandando** » Sun Sep 13, 2009 9:52 am

When landing at the smaller 2d airport (not Juliana ) in Saint Martin the runway disapears and touchdown is actually below the scenery level you can see from the air. I have tried uninstalling and installing again a couple of times with no results. Also I have noticed that removing the addon scenery Fly Tampa folder does not completly uninstall Saint Martin- Saint Barts, is there a better way of doing this?
I would like to fix this since I do much of my flying between these islands!

Post by **martin[flytampa]** » Sun Sep 13, 2009 4:46 pm

Grand Case TFFG is completely untouched as far as our TNCM/Complete scenery is concerned, meaning it remains in its default state.

To test this, remove the entry "FlyTampa-Maarten" from the FSX Scenery Library, but keep the entry "St Maarten" (further down the list) which is default.

Then remove the files: fsx/scenery/world/scenery/
AFX_TNCM_flytampa_dummy.bgl
AFX_TFFJ_flytampa_dummy.bgl
AFX_SABA_flytampa_dummy.bgl

If the islands are not restored to default after this, check for possible other Caribbean sceneries.

wallabi · Post by **wallabi** » Mon Sep 14, 2009 10:46 am

by the way, i have a question; i want to know why Fly Marteen/Fly Tampa don't touch TFFG ?

Thank you.

Post by **martin[flytampa]** » Mon Sep 14, 2009 4:57 pm

wallabi wrote:by the way, i have a question; i want to know why Fly Marteen/Fly Tampa don't touch TFFG ?

Becuase after 12 months in development I had to set a limit, which was the 3 airport that are covered.

wallabi · Post by **wallabi** » Tue Sep 15, 2009 10:43 am

ok, thank you