SOS-my AI heavies keep going missed

M.D.Miron · Post by **M.D.Miron** » Sat Apr 14, 2007 1:30 pm

Dear All,

I have noticed an interesting/intriguing issue - all my AI heavies except the KLM B744 keep declaring going missed. Sofar I didn't encounter this type of issue elsewhere

.
taking into consideration that spotting landing AI is non neglectable part of our simming pleasure, your valuable advice is much appreciated.

Many thanks in advance.

Edit/Addendum: TNCM by C.Delblond was correctly removed, incl its proper afcad2. No relicts. In that scenery, all was running fine.

Post by **george[flytampa]** » Sat Apr 14, 2007 1:47 pm

It's running fine now after removing the Delblond Afcad?

M.D.Miron · Post by **M.D.Miron** » Sat Apr 14, 2007 2:05 pm

george[flytampa] wrote:It's running fine now after removing the Delblond Afcad?

Hi George and thanks.

My edit was a little clumsy I must confess. I wanted to say that before installing FT scenery, I removed Delblond's scenery including its afcad and ran a clean FT install. Now I have the heavies going missed, an issue which wasnt happening in Delblond scenery.

M.D.

Post by **george[flytampa]** » Sat Apr 14, 2007 9:24 pm

Can they get in on a second try?
Sometimes AI freaks out when it first spawns.

Mine seem ok here. But I did see a US Airways 757 with gear down at 10,000ft

The rest of them landed fine.

jackcford · Post by **jackcford** » Sun Apr 15, 2007 3:07 am

If there is simply too much traffic for the poor virtual controller to handle AISmooth sorts it out.....

Jack

jorgehmosteiro · Post by **jorgehmosteiro** » Sun Apr 15, 2007 11:42 am

My traffic AI (heavies too) land in the sea

paavo · Post by **paavo** » Sun Apr 15, 2007 11:46 am

jorgehmosteiro wrote:My traffic AI (heavies too) land in the sea

LMAO...............

Check for multiple afcads, if you use utlimate traffic or traffic 2005 you need to disable the afcads that come with them.

skydvdan · Post by **skydvdan** » Sun Apr 15, 2007 11:53 am

I think that's an issue with the aircraft's flight dynamics. Is it PAI?

paavo · Post by **paavo** » Sun Apr 15, 2007 11:55 am

jorgehmosteiro wrote:My traffic AI (heavies too) land in the sea

How far from land is that thing ?

jorgehmosteiro · Post by **jorgehmosteiro** » Sun Apr 15, 2007 11:59 am

Using scan Afcad, I found this files:

AF2_TNCM_flytampa_dummy.BGL and AF2_TNCM.BGL

Can I delete one of then?

Ruahrc · Post by **Ruahrc** » Sun Apr 15, 2007 12:00 pm

I've seen that kind of thing (landing short of the runway) happen at other airports too. Usually in that beginngin phase hwere airplanes are still sorting themselves out after the big spawn rush.

Ruahrc

paavo · Post by **paavo** » Sun Apr 15, 2007 12:00 pm

jorgehmosteiro wrote:Using scan Afcad, I found this files:

AF2_TNCM_flytampa_dummy.BGL and AF2_TNCM.BGL

Can I delete one of then?

No, you need both of those.

paavo · Post by **paavo** » Sun Apr 15, 2007 12:01 pm

Is everything landing like that, GA and Commercial traffic ?

jorgehmosteiro · Post by **jorgehmosteiro** » Sun Apr 15, 2007 12:10 pm

No, just the heavies planes