Tarmac texture disappears in YSSY (FlyTampa YSSY v2.1 and Orbx Australia v2)

[beowulf_222]

Hey there,

I recently experienced a strange and persistent behavior when it comes to FlyTampa YSSY v2.1 and Orbx Australia v2. When I load the scenery, once the aircraft has finished loading (a PMDG aircraft), the tarmac disappears and just dirt shows.
Now, I told Orbx Australia under settings that I have FlyTampa as scenery, and it's always worked so far. I didn't change anything expect for buying and adding YBBN and NZ South Island scenery.
I am attaching a picture of how it looks like. In an older forum post I found a hint about adjusting the order of the scenery layers, but they are all greyed out and cannot be moved.

So, I am wondering if anyone has experienced something like this before and/or has an idea where to look? It appears the tarmac layer does load initially and then just disappears.

Thanks!

-- nick

[george[flytampa]]

There is some stuff in the manual about compatibility with Orbx AUS V2. Have you followed those instructions.

[beowulf_222]

Yes, I did.
As I wrote, it used to work just fine. I don't know what changed suddenly to make it behave like this.

The only thing I am unable to do as per the manual is to move the entries called FTXAUv2_07_MESH, FTXAUv2_06_CVX, FTXAUv2_09_EXCLUDES and FTXAUv2_05_SCENERY and the Entry for Flytampa-Sydney because they are greyed out.