Regards
- CORSAIRONE-2020-oct-4-004.jpg (381.22 KiB) Viewed 3497 times
- CORSAIRONE-2020-oct-4-003.jpg (359.3 KiB) Viewed 3497 times
- CORSAIRONE-2020-oct-4-001.jpg (339.38 KiB) Viewed 3497 times
Just Installed v2 - SOLVED!!...Thanks!!
- canadagoose
- Posts: 24
Just Installed v2 - SOLVED!!...Thanks!!
I have installed V2 using the Universal installer into the P3D folder and like all my other Fly Tampa Airports I moved them manually to a different Location (Drive). These pix are what I see. There are no terminal buildings and the runways have no markings. I use LORBY Organizer to add the Airport into the scenery Library. I also purchased Copenhagen and it works fine using the same procedure. I have also turned off the appropriate ORBX AU2 FTX & ADE files as per another thread (http://www.flytampa.org/forum/viewtopic ... 30&t=14215). BTW, Sydney V1 one worked OK as well:
Regards
Regards
Last edited by canadagoose on Sun Oct 04, 2020 1:10 pm, edited 1 time in total.
- george[flytampa]
- Site Admin
- Posts: 3868
Re: Just Installed v2
Make sure it is not in the scenery library but listed under addons. It should be greyed out in the scenery library.
- canadagoose
- Posts: 24
Re: Just Installed v2
Thanks for the quick reply. Both Sydney and Copenhagen are not greyed out and EKCH works fine. So, not sure what to do to get it greyed out. I think I can use LORBY? BTW I also noticed when choosing the airport there was an airport listed as ZSSY. I know this is a dummy trick ORBX use in their sceneries.
Regards
Regards
- george[flytampa]
- Site Admin
- Posts: 3868
Re: Just Installed v2
Remove it from the scenery library. Re-install using our installer. It will add the scenery to addons for you.
- canadagoose
- Posts: 24
Re: Just Installed v2
Will do. So, the scenery was not added to the addons during the first install? I still want to manually move the scenery to my own location.
- george[flytampa]
- Site Admin
- Posts: 3868
Re: Just Installed v2
Check it works before you move it. There's instructions on how to move it later in the manual.
- canadagoose
- Posts: 24
Re: Just Installed v2 - SOLVED!!...Thanks!!
I did not re-install the Airport. I simply deleted the airport in LORBY and re-Added it via .xml format. Sydney PBR looks Fantastic!! I thought I had added it correctly the first time, obviously not. I always feel things are not as bad as they first appear and this seems to be the case here. Thanks for your guidance FlyTampa! Patiently looking forward to KATL.
Regards
TS
Regards
TS