Problems at YSSY
- mcbellette
- Posts: 57
Problems at YSSY
Hi all, I'm getting jagged edges where the rock wall meets Botany Bay and I'm also having troubles with the road either side of the runway tunnel near the ATC tower. Please see attached picture. Hoping someone can help me out. I'm running P3D V4, along with ORBX Australia (all ORBX products up-to-date).
- Attachments
-
- Sydney problems.jpg (388.55 KiB) Viewed 1645 times
- george[flytampa]
- Site Admin
- Posts: 3867
Re: Problems at YSSY
None of our objects are loading in your shot. Orbx must be excluding them.
Try the fix listed here..
https://ft:forum@www.flytampa.org/forum ... 30&t=13356
Make sure you have the Sydney P3D patch installed
https://ft:forum@www.flytampa.org/forum ... =1&t=13842
Jagged edges. Set mesh resolution to 10m or higher.
Try the fix listed here..
https://ft:forum@www.flytampa.org/forum ... 30&t=13356
Make sure you have the Sydney P3D patch installed
https://ft:forum@www.flytampa.org/forum ... =1&t=13842
Jagged edges. Set mesh resolution to 10m or higher.