X plane Copenhagen - conversion tool dont convert all tile

[morst]

Hey

Had another look around the converted tile for Copenhagen. large Areas Are “default” scenery blending with the converted orthoscenery.
When I look in the tile texture folder all Go texture files look right and the converted tile i correctly placed in scenery.ini as you descriped in another thread and shows correct around Copenhagen and large part of the sjaelland Island but not Down in the South part and north part as shown in the pictures. Can you figure out heats is wrong. ??
Also made a post at corfu. The lower 50% of the tile is also deFault scenery.

Regards
Morten

[Yannis[flytampa]]

did you use mixed zoom levels (higher level over airports) when you created your original ortho4xp tiles ?

[morst]

No - did the tile GO zoom 16 for Hole tile. Have tried Making the tile 2 times and converting from different sorces arc, go etc. The same problem is with corfu 39-020 half of the tile is with default terrain in the conrverted tile.

Have all Europe and half of usa ortho4xp and nevet experienced that some Of the tile is with default terrain.

If i look in the texture folder of the converted tile all texture files look fine.

Mmmm.... Strange but has something to do with the conversion because no problem with tile before conversion - But then there ofcourse is problems with the airport. The airport and city looks perfect.

Regards
Morten

[morst]

The problem was When I zoom out from ekch with shift+4 some of the tile is default textures. When I fly and get near to the specific area - the default textures convert to ortho4xp In flight. So Not A big problem 😊 anymore. Thank you again for the best scenery pack ever Seen. Really love ekch and Copenhagen!
Keep up the great work - and great customer service.

Cheers
Morten

[emilios[flytampa]]

Thanks for the kind words Morten. The zoom in/out issue might have something to do with XPlane, not sure at the moment but it looks like you are sotred now :)