No Terminal and other objects

Post Reply
Posts: 9

No Terminal and other objects

Post by Tamba765 » Thu Feb 14, 2019 11:51 pm

I just did a clean installation (uninstalled previous version) of StMaarten V1.9. There were no problems during the installation and the configurator had all the options for the new version. When the scenery loaded into the simulator (P3Dv4.4), there was no Terminal, Hotels, Runway Markings or Ramp Pavement. The SODE jetways were present and worked OK. I tried to uninstall and reinstall, but no luck. Also, if I do manage to get this working, is the patch still necessary? I have high end hardware and no anti virus or firewalls active. Any ideas?Thanks.
Pete Locascio
Site Admin
Posts: 5185

Re: No Terminal and other objects

Post by martin[flytampa] » Fri Feb 15, 2019 1:22 am

It sounds like a double entry in the old scenery.cfg. The new version (doesn't need patch) adds itself to add-ons.cfg, so its entry is gray and on top of the List. But you most likely have another entry further down the list also pointing to /Prepar3D v4/FlyTampa/StMaarten/ Could be under a different name but pointing to that same folder. If you can find it, check scenery.cfg in Notepad.
Posts: 1

No Terminal and other objects

Post by AlekcemlVevy » Fri Sep 06, 2019 8:18 pm

Thank you for your reply.

I have tested uncheck the main terminal function, but still the terminal shows up twice in the terminal strip report.

Its possible to do it without the terminal shows up twice?
Post Reply