Glitching ground textures

[Boeingman07]

Hi, I updated all my scenery to P3D V4 again to make sure I did it properly and discovered an issue while on stand at Toronto. I don't know if this is a layering issue or not but I do run ORBX Global and OpenLC NA but they are all at the bottom and in default order. The flytampa libraries section I just put below all my flytampa scenery. I only discovered this when I was at a different part of the airport, gate C36, which may be the reason why I haven't seen it before if it was/is an actual issue. The glitch does start to move around at times as well. Here are some pictures.

[NBouc]

Hi Boeingman07,

I don't know for sure if it would solve your problem, but using Open LC NA myself, I always deactivate Fly Tampa's Toronto_LC in P3Dv4 scenery libraries to avoid conflict between the 2 LCs. I do the same with Sydney_LC since I am using ORBX Australia.

It might be worth trying since I don't have the problem you describe in CYYZ on my system. Best regards,

Normand.

[Boeingman07]

Hi, yes I've done that from the start after noticing that the two do not mesh well together. Thanks for that initial advice though

[martin[flytampa]]

Can you try the following:
1. Delete: /FlyTampa/Toronto/scenery/cyyz_terrain.bgl
2. Redownload the v4 TOR patch: http://www.flytampa.org/dwl/CYYZ_P3Dv4_Patch.zip
3. Reapply the patch and check that afterwards you have these files:

- /FlyTampa/Toronto/scenery/cyyz_terrain.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain0.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain1.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain2.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain3.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain4.bgl
- /FlyTampa/Toronto/scenery/cyyz_terrain5.bgl