Gate 54 crash/collision on pushback

[uberwolfe]

Hi all, just bought this scenery and I have to say it looks amazing.

Unfortunately on my first flight, I seem to be colliding with something invisible a few seconds after commencing my pushback from domestic gate 54..

There is nothing surrounding the aircraft that is close enough to warrant a crash... I know I could turn off collisions but that is not how I fly.

I tried gate 56 and there is no problem.

Does anybody have any idea what could be going on? Could it be related to left over bits from the legacy FSX YSSY that haven't been cleared properly when the airport was installed?

Any suggestions would be much appreciated.

[george[flytampa]]

I can't find anything causing collisions around Gate 54.

Check you scenery library for older SYD scenery if you suspect something is left over.

[uberwolfe]

Thanks for the reply George.

There are no YSSY bits in any of my addons, and flyTampa YSSY is at the top of my scenery priority list.

I get this problem in both PMDG 737 and Majestic Dash 8.

It's literally like a few feet into the pushback where the problem occurs.

[mcbellette]

I turn off collision detection.

[uberwolfe]

I know I could turn off collision detection, but that's not a proper solution... something in that spot is interfering with my aircraft.

It would be helpful if anyone else could see if they have the same problem in a 737 with collisions on. I would like to know if it's specific to my system...

[capt sl]

had no issues . pushbacked fine . both using either shift-p or the GSX pushback

[uberwolfe]

Thanks for confirming capt sl.

Looks like I have to avoid that gate then...