-
emilios[flytampa]
- Site Admin
- Posts: 1626
Post
by emilios[flytampa] » Fri Apr 26, 2019 4:08 am
26L ILS frequency update
- Run FT-Configurator and switch your airport setup to 'Standard Crosswing'
- Unzip attached file and drop all 3 extracted files into '\P3D\FlyTampa\LasVegas\scenery' and replace all
FSGU mesh
The new updated mesh is
Place this into your P3D\FlyTampa\LasVegas\scenery
and replace when asked.
This should sort out your FSGU issues, please let us know if not.
-
panzer2181
- Posts: 19
Post
by panzer2181 » Sat Apr 27, 2019 9:18 pm
Is that hotfix included in the latest version downloaded today?
-
trisho0
- Posts: 338
Post
by trisho0 » Sat Apr 27, 2019 10:27 pm
That hotfix of z_terrain_LasVegas_mesh.bgl file only for KLAS with ORBX? Will this resolve the water holes?
-
emilios[flytampa]
- Site Admin
- Posts: 1626
Post
by emilios[flytampa] » Sun Apr 28, 2019 4:21 am
The mesh update fixes FSGU mesh issues. We ll have a separate small patch for those mesh holes, and it will all be soon included in an updated installer
-
lucagigli
- Posts: 9
Post
by lucagigli » Sun Apr 28, 2019 5:56 am
No, the FSGU patch do not resolve the elevation issue in my scenery. The runways and all the airport are underground. I had the same problem in the past with Fsdreamteam KLAS scenery, without solutions. Now I try deleting the FTX files as I have read in other topics in this forum.
Luca
-
lucagigli
- Posts: 9
Post
by lucagigli » Wed May 01, 2019 3:54 am
lucagigli wrote: ↑Sun Apr 28, 2019 5:56 am
No, the FSGU patch do not resolve the elevation issue in my scenery. The runways and all the airport are underground. I had the same problem in the past with Fsdreamteam KLAS scenery, without solutions. Now I try deleting the FTX files as I have read in other topics in this forum.
Luca
I've solved with the the tips in other topics, deactivating files in Orbx Scenery directory and deactivanting KLAS in Ftx Vector. Now KLAS scenery is ok, except for an issue: there three big puddles in a taxiway crossroad near the main apron
Luca
-
data63
- Posts: 10
Post
by data63 » Wed May 01, 2019 6:48 am
lucagigli wrote: ↑Sun Apr 28, 2019 5:56 am
No, the FSGU patch do not resolve the elevation issue in my scenery. The runways and all the airport are underground. I had the same problem in the past with Fsdreamteam KLAS scenery, without solutions. Now I try deleting the FTX files as I have read in other topics in this forum.
Luca
if you have the same problem with FSDT AND FlyTampa there is a great chance the problem is in your setup.
did you check for other KLAS files eg. in scenery/world or in some traffic-Addon folders?
The MESH problem is about some steep cliffs around the airports caused by the layout of KLAS in reality which isn't flat but descends from east to west.
Runways "under ground" are normally caused by a worng ALT file or a foreugn AFCAD that doesn't fit the scenery
Addendum - Sorry: I read your last post only after submitting mine, so you found it ;-)
