When I change runway in configurator elevation issue

Post Reply
bazzachazza
Posts: 4

When I change runway in configurator elevation issue

Post by bazzachazza » Wed Sep 01, 2021 6:03 am

Afternoon when I manual or through the configurator change from ALL runways open to a specified direction the airport elevation is off. I and AI traffic appear below the surface. Is there a difference in airport elevation in the ALL runways open file to the others that causes this ? When I change back the to ALL runways the airport elevation is normal but I get departures taxiing for a 06 or 36R departure which isn't optimal. Many Thanks.
bazzachazza
Posts: 4

Re: When I change runway in configurator elevation issue

Post by bazzachazza » Wed Sep 01, 2021 6:47 am

Also, should there be a landclass file with the install I can't find one ?
bazzachazza
Posts: 4

Re: When I change runway in configurator elevation issue

Post by bazzachazza » Thu Sep 09, 2021 10:22 am

Thanks for the support
Er!k
Posts: 392

Re: When I change runway in configurator elevation issue

Post by Er!k » Sat Sep 11, 2021 1:16 pm

I heavily modified the AFCAD for EHAM, with all airlines and runway config as realistic as technically possible. YOu can try it by replacing the ADEX_FLYTAMPA_EHAM_2016_ALLRWYSOPEN.bgl file. Always make a back-up, just in case!
ADEX_FLYTAMPA_EHAM_2016_ALLRWYSOPEN.zip
(30.16 KiB) Downloaded 9 times
bazzachazza
Posts: 4

Re: When I change runway in configurator elevation issue

Post by bazzachazza » Tue Sep 14, 2021 3:37 am

Thanks Er!k I'll give it a try.
Post Reply