z28 wrote:I found the solution!!!!
Move the "AFX_EHAM_flytampa_dummy.bgl" file from World/scenery folder to Base/scenery folder.

All credits to you for this solution.

Hi, I have the same problem with EHAM and all the solutions, mentioned here, didn`t help me. I put the dummy-file in WORLD/SCENERY and moved it to BASE/SCENERY. Absolutely no change. The airport is about 40 ft above me. Any other suggestions? Thanks for help, Ulli Thanks for this tip. Solved this i...

Thank you for yet a wonderful product George. After deleting the old libraries I ran the installer for the new library and configurator and expected to find a new entry in my scenery library but it wasn't there? I had to add the library manually from the new location; FSX/Fly Tampa/. Is that correct...

I don't use Orbx Vector, only Global and EU_LC.

Sure can. I have marked a few of them in the attached pictures. If you look closely you will see lots more.

Just noticed at night that some FTX vector street lights is appearing inside the airport and the whole scenery area. Any way of removing them? It is quite annoying with a streetlight in the middle of a taxiway or in the middle of the apron. I know that I can turn them off but that will make the whol...

Just flew in and landed on 04L. Frames only dropped below 30 when I crosses 12/30 on A and then went back up.

I can confirm this issue coming from A to Holding point A1.

You need a top end system to run this with the NGX or 777. So You need to cut down on the details with the configurator tool. With that said my biggest problem is VAS usage because I am running FTX Global and LC along with the very nice Denmark freeware package and Denmark Map X Vector. I haven't ev...

I am sorry to tell that I don't have any fps issues at the gates with the NGX. 30 locked in spot view and 20-30 in VC.

That file did it. Thanks for your superb support. I did find out that it was the Denmark scenery v. 1.4 that was causing the trouble not FSGenesis. Trying to find the conflicting BGL was impossible since there are 480 files in the Denmark 1.4 scenery folder and none of the obvious like Amager_flatte...

I have FSGenesis mesh, FTX Global and LC installed. I uninstalled Scansim EKCH prior to installation. Also I have Denmark freeware scenery and Denmark X vector 2.1. Cannot get rid of the trench with any setting inside FSX. Must be a scenery conflict then.

Hi Emil

The ditch with rail tracks is also present with 2m mesh. My mesh complexity is at 100. Level of detail radius is at max.
The colour mismatch is only on the inside. I use custom autogen.
Will try your exact settings though.

Thanks for a wonderful scenery. The attention to detail is just fantastic. I have been slewing around to check all parts of the scenery and found two places with issues on my system. FSX dx9. running with 5m mesh setting and the rest at max. Season is November. The sound barrier to the west seems mi...