As I found out elsewhere on this forum the Ctrl+J only moves one jetway on gates (for Heavy aircraft) where there are two. Before I bought Fly Tampa EHAM I had created dual gates on many gates using GSX level 2 on the default P3D airport. These have all been deleted before the install of FT-EHAM.
I tried to exludes the gates and replace them by SODE driven gates through GSX level 2. But then I still see the 'not active' gate. Probably because it is hard-coded in the bgl.
Does anyone have a solution to make this work. I mean remove all the 'second jetways per gate', so GSX level can be used to created the dual jetways?
Would be very nice to have.
Dirk
FOUND THE SOLUTION. It is just a 1 minute job.
Go to D:\P3Dv4\FlyTampa\Amsterdam\scenery and change the xtension of jets-static.bgl into .off
piece of cake
Dual Jetways on gate and GSX level 2
Re: Dual Jetways on gate and GSX level 2
Hey, is there any way you can share your file for the dual jetways at Schipol? Would be much appreciated.