Copenhagen Update V1.1 [Released November 18th 2014]

[emilios[flytampa]]

V1.1 gives me also bad framrates. in 1.0 i get 26 -30. I v1.1 i hardly touch the 20.
Configurator settings are the same.

Have you made no other changes (i.e. AES jetways installed?) in-between?

No, nothing. No AES installed. I'm back at 1.0 and frames are ok again.

Please send an email to support@flytampa.com, and we can go step-by-step on installing v1.1 to see where the problem is in your setup.

[emilios[flytampa]]

I have double Jetways !

I use FSX and AES !
wants going wrong ?

best regards

It's an AES issue.
Drop the attached file into FSXMain folder\Aerosoft\AES\scenery folder.
Also make sure AES is at the top of your scenery library in FSX.

[fabiokso]

very poor performance also here, nothing has changed with 1.1, landing with NGX at EKCH gives me OOM error, which does not happen in any other airport ;( and very poor frame rate.
fabio

[henry]

Tried a lot of gates and still no moving jetways with Ctrl & J, the assignment is correct in FSX.

Do not have AES for this airport.

[henry]

Do not know why but I have got the jetways moving.

[hjmx]

Sorry, where do I get this update? It feels strange for me that you announce an update but not showing where/how to get? Or am I dumb?

Harry

[hjmx]

I AM DUMB. Found it!

[Nicko Brännlund]

+1 Also have poor performance, barely reaching 11 fps in the NGX on the 1.1 update

[CPH93]

I'm also having bad perfomance. especially near the Terminal 1-2 area, my fps drops Down from 30+ to 10-12.
I have the 1.1 update installed too.

[Sam]

Also have the problem

Plot twist: In FSX its fine, p3d I have serious problems
I know you cannot compare the sims side by side, I feel however something might have gone wrong in the 1.1 install on P3D

Settings is ofc not the same I have spent quite some time getting the performance right, and the sliders isnt put to the right and I only enabled cloud shadows... But performance at OMDB or AS ENGM v 2.0 is much better compared to Copenhagen on my setup.

REX textures is the same in both sims

Settings in the config: Apron light effects, 3D city lights, Animated windsocks, Custom trees , Apron detail Normal, parking vehicle density normal, All jetways animated.

On approach to the airport today I was spiking at 8-14 FPS.. 22-25 when I was down on the runway

Any ideas?? I have read around on the forums, but none of the tips seemed p3d specific.

No oom problems tho