Fresh install v2.1, ORBX NL on P3D V5.4

[yvesamuel]

Hi,

I fully reinstalled my PC. Since the reinstallation, I have the altitude problem at EHAM.
I deasctivated the dumm bgl, surched on your forum, on the ORBX forum, but did not find a solution.
I have tried nearly everything : change the roder of the scenery èEHAM over then under ORBX, over and unfer the libraries), desactivated the amsterdam's bgl.
I'm trying for 3 days and would like to fly fromand to EHAM.

What else could I try?
Thank's and best regards

Yves from ELLX

[yvesamuel]

Hi there,

It would be so nice to have an answer...

Yves

[yvesamuel]

A screen shot...

Thank's for help
Yves

EHAM.jpg (781.19 KiB) Viewed 2444 times

[yvesamuel]

Hi,

One week without any answer.
Thank's to the devs!!!

Yves

[emilios[flytampa]]

What did you mean by 'I deasctivated the dumm bgl'. That was only meant to be relevant to earlier versions of EHAM, but after v2, there is no need for any manual input. Can you take a shot of scenery library after installation? Was EHAM working fine before re-installing your PC/software?

[yvesamuel]

Hi Emilios,

Thank's for your answer.
After reading your answer, I totaly reinstalled EHAM after having deleted my install. I also deleted the xml file.
No change.
In fact I fully reinstalled my PC, P3D v.4, but kept all my sceneries as all of them are installed in a directory outside P3D, names scenes.
I just asked ORBX to resynchronize P3D.
All my other sceneries work well, included all my FT sceneries, except EHAM.
I just modified the laye of EHAM, because the layer you pu (264à is much to low for me. I have now EHAM nearly on top of my layers.
What did I wrong? Should I reinstall ORBX NL?

Thank's
Yves

[yvesamuel]

I ave tries everything. No solution.
What should be the sceneries order?

h=Thank's
Yves

[yvesamuel]

Hi Emilios,

Found the solution!!!
I desinstalled EHAM and ORBX NL, reistalled EHAM, verified the layers, then ORBX NL. I desactiaved the 3 EHAM files in scenery, and now I can fly to and from EHAM.

Have a good evening
Yes

[tampaboy25]

Hi @yvesamuel. I am having the same issues. What 3 files have you deleted ad what ORBX layer did you use?
My plane is half inside the ground.

2023-10-9_17-16-4-299.jpg (930.41 KiB) Viewed 1972 times