EHAM jetways wrong side & old airport layout.

[davewing]

In version XP11 the jetways go to the wrong side.
And missing taxiway A and B. It is the old airport layout with taxiway Q.
macOS 10.15.7

a321_XP11 - EHAM.jpg (760.29 KiB) Viewed 3330 times

[gr8mac]

I have the same.
X-Plane 12, macOS 13.1
Mac Studio Max

[emilios[flytampa]]

Try restarting the sim for resetting jetway orientation.

[gr8mac]

Try restarting the sim for resetting jetway orientation.

Done that multiple times, also re-installed the scenery, deleted scenery.ini.
Stays the same

[emilios[flytampa]]

can you pleasea attach the 'sam.xml' located in 'X-Plane 11\Custom Scenery\FlyTampa_Amsterdam_0_airport' ?

[baires]

Thank you for the feedback related to Xplane....

Hopefully, as the MSFS2020 version is still in development, I'm crossing fingers that the Taxiway Q will be updated for MSFS....

Warm regards,

Rafael

[DrMarkLV]

can you pleasea attach the 'sam.xml' located in 'X-Plane 11\Custom Scenery\FlyTampa_Amsterdam_0_airport' ?

Any solution found to correct jetway disorientation in XP-12?

[gr8mac]

I assume the reason is that the SAM plugin is not native to Apple Silicon?
So, the plugin is not loaded when using X-Plane 12 without Rosetta, therefore the jetways are incorrect...?

[gr8mac]

I assume the reason is that the SAM plugin is not native to Apple Silicon?
So, the plugin is not loaded when using X-Plane 12 without Rosetta, therefore the jetways are incorrect...?

Let me reply to my own question.
That is a YES

When I run X-Plane 12 in "Rosetta mode" the SAM 3 plugin loads, and the jetways are good.

In X-Plane 11 it always works, as that is Intel-only, thus SAM 3 loads correctly, and so the jetways are good too.