Error opening file

speedbird144 · Post by **speedbird144** » Fri Mar 01, 2019 9:38 am

Trying to update to the latest version using installer but getting an error:

"Error opening filefor writing:
E:\P3D\FlyTampa\mages\ramp_people.png"
Click abort to stop the installation...

Post by **martin[flytampa]** » Fri Mar 01, 2019 10:56 am

This can happen if you have the FlyTampa-Configurator open while installing. If thats the case, you can click "Ignore" on those error messages, as it is just trying to overwrite the same files currently open by the Configurator. The Installation of the Airport will complete without problems even with those errors ignored.

speedbird144 · Post by **speedbird144** » Fri Mar 01, 2019 4:13 pm

Thanks for the reply. Yes, the configurator was open after I updated LOWW. Looks good now.

Post by **AvalonBic** » Thu Oct 03, 2019 9:21 pm

When I try to create a new 3d model I get the following error: "error opening prototype model file"
c:program filest-flext-flex parametric cade 11programtemplateansi 3d front right bottom workplanes.grb
Any ideas?