SODE Jetways not connecting properly

[gvert]

Hello guys!

I just noticed a problem with the SODE Jetways in Toronto 1.4. Using P3D v4.4.
Only noticed the not properly connecting jetways in Toronto. Checked it with the same aircraft e.g. in Brussels and Billund without any problem.

I also tried several stands in CYYZ, with the same result. Some pics below.

Thanks in advance!

[george[flytampa]]

The aircraft door position is probably incorrect.

[gvert]

The aircraft door position is probably incorrect.

Nope. It's definitely on the right spot, as it is working at any other airport. Toronto is the only airport causing this problem. Checked that already with the guys over at Leonardo.

[Tinosky]

I also get this issue with the QW 789. Sode is not aligning properly but, they do at other airports.

[george[flytampa]]

I don't have that aircraft(even tho I want it) but gate B12 is working fine my end...

[gvert]

Weird...cause the parameters inside the aircraft.cfg are definitely correct...I can check other planes too, haven't done that yet on my fresh P3D installation, on a new PC. But I remember problems on the QW787 that was mentioned, aswell.

[epiccuber2]

is there a chance you can try the aerosoft a320 because every time I try the jetway goes in the aircraft and is to low