Dubai 2.4 ground visible through taxiway

[Nepomuk]

Hello Flytampa!
Using P3DV4 and Dubai 2.4 i notice at some locations i experience a layer problem. I´ve had the same issue with P3D2.4 and Dubai 2.3:

omdb1.jpg (84.72 KiB) Viewed 4955 times

The issue is only visible when viewing in a flat angle:

omdb2.jpg (86.42 KiB) Viewed 4955 times

At some location the taxiway lines got overlayed:

omdb3.jpg (114.23 KiB) Viewed 4955 times

I disabled the Mesh, vector and the LC, but without success.


Addons:
Mesh FS Global 2010,ORBX Global Base, ORBX Global Vector, ORBX LC EU

[Nepomuk]

Hello!
Is there noone to confirm this problem or is there anything missing int the problem description?

Regards
Stephan

[martin[flytampa]]

I have not seen or had this problem reported before sorry. It must be some incompatibility.

[Nepomuk]

Hello Martin!
I disabled all 3rd pary scenery except Dubai and the issue is still there. I would appreciate if you could check the scenery near taxiway M7 on your setup.
If you don´t see the issue i will make a complete clean P3DV3 installation.

Regards
Stephan

[martin[flytampa]]

Saw it now, only in this particular spot by M7, nowhere else Very odd oval shaped area that flickers, no idea what may cause it. Will post a fix if I can figure it out.

[Nepomuk]

Any news on this topic?
I experience the same issue at Vienna and Copenhagen. May it be related to P3D?

Regards
Nepo