Hi
I installed V1.8 St Maarten Complete into P3D V3 by pointing as instructed to the P3D V3 root directory. I was getting such bad elevation problems with TNCM I uninstalled using the uninstaller. The only way I could get the default P3D scenery back fpr TNCM without the elevation problem with TNCM was to manually remove the AFX_TNCMflytampa_dummy.blg file after the uninstall. I Removed the SABA dummy file to hopefully revert SABA back to the default but P3D would not open SABA default without the SABA dummy file and without it loads briefly and reverts to the opening Eglin default airport. With the SABA dummy file SABA does open the default airport but the elevation issues are there. TNCM opens to default without the dummy file but SABA won't. All my other FlyTampa airports are fine in P3D V3.
My only addon that affects that part of the world is FTX Global. I'm hoping someone can help with this rather complex issue.
Many Thanks
simdown42
St Maarten P3DV3 Install and Elevation Problem
Re: St Maarten P3DV3 Install and Elevation Problem
Hi
Well I give up! Just for a try I reinstalled St Maarten 1.8 into P3D V3 and all is now fine. Exactly the same install procedure. No tweaks
Go figure!
Cheers
simdown42
Well I give up! Just for a try I reinstalled St Maarten 1.8 into P3D V3 and all is now fine. Exactly the same install procedure. No tweaks
Go figure!
Cheers
simdown42