Number of World Objects & Ground Issue

Post Reply
Michael_B737NG
Posts: 4

Number of World Objects & Ground Issue

Post by Michael_B737NG » Sat Jul 25, 2020 1:20 am

Hi,

If I run the number of world objects at minimal I get a hole in the ground that wraps around most of the airport, If I move world objects to low the problem disappears as seen in the photos below.
Attachments
klas1.jpg
klas1.jpg (296.06 KiB) Viewed 122 times
klas2.jpg
klas2.jpg (165.71 KiB) Viewed 122 times
emilios[flytampa]
Site Admin
Posts: 1251

Re: Number of World Objects & Ground Issue

Post by emilios[flytampa] » Sat Jul 25, 2020 5:55 am

In the latest versions of XPlane, the minimal setting will strip everything out of the sim, keeping only stock/default Xplane objects. I think earlier versions allowed us to go as far back as minimal.

Our objects are already set to appear at minimum allowable density (except heavier models, ie static A/C etc.). The lowest you can go to get the scenery appearing correct is 'Low'.
Post Reply