AI taxi into position and hold behavior at 8L

Post Reply
SolRayz
Posts: 22

AI taxi into position and hold behavior at 8L

Post by SolRayz » Mon Jun 15, 2020 12:50 am

ATC will clear AI to taxi into position and hold, but the hold position is at the foot of 1L causing arriving AI for 1L to go around over and over again. Something is not right with this. Can you adjust the position please?

As you can see in the pic, Delta holding at 8L sitting at the 1L threshold. This causes repeated go arounds for incoming aircraft.

Image
SolRayz
Posts: 22

Re: AI taxi into position and hold behavior at 8L

Post by SolRayz » Fri Jun 19, 2020 9:15 pm

I guess issues like this will be ignored. You put so much effort into this scenery, only to leave it with imperfections. Great modus operandi.
stro19
Posts: 9

Re: AI taxi into position and hold behavior at 8L

Post by stro19 » Fri Jun 19, 2020 9:42 pm

Yeah I reported this issue several times. Thats the wrong position, they are supposed to be taking off before 1R and they never responded.
SolRayz
Posts: 22

Re: AI taxi into position and hold behavior at 8L

Post by SolRayz » Sat Jun 20, 2020 12:21 am

Also occasionally AI will get stuck there causing a huge backup, and is eventually deleted.
emilios[flytampa]
Site Admin
Posts: 1160

Re: AI taxi into position and hold behavior at 8L

Post by emilios[flytampa] » Sun Jun 21, 2020 5:01 pm

An ATC engine issue where it cannot handle traffic gaps effectively, a workaround is posted in the updated AFCAD here: viewtopic.php?f=34&t=14043
SolRayz
Posts: 22

Re: AI taxi into position and hold behavior at 8L

Post by SolRayz » Tue Jun 23, 2020 8:24 pm

I can confirm that the issue is improved. Thank you!
Post Reply