FlyTampa Amsterdam and ORBX Netherlands city autogen

Post Reply
Emile
Posts: 1

FlyTampa Amsterdam and ORBX Netherlands city autogen

Post by Emile » Sun Sep 09, 2018 8:26 am

Gentelmen.
I have recently introduced FlyTampa Amsterdam on top of my ORBX Netherlands in the scenery config file.
FlyTampa has the patch installed as I have a Prepar3D V4 Flightsim installation.
Schiphol airport works beautiful however when i fly in from the north over Amsterdam Center towards Schiphol i can see that part of my ORBX Netherlands autogen produced buildings have disappeard.
When I switch off FlyTampa Amsterdam in the Scenery config file the buildings appear again.
So i wonder if there is, or needs to be created, a special FlyTampa ORBX Netherlands related file that illiminates all influences to the sceneries that are outside the Schiphol perimiter.
Have a look at my screendumps and you will see clearly what i mean. These are not the only area's that are affected by FlyTamp Amstredam. I just copied the most impotent once.
Your advice is appreciated
Attachments
ORBX Nederland samen met FlyTampa Amsterdam.jpg
ORBX Nederland samen met FlyTampa Amsterdam.jpg (329.77 KiB) Viewed 1466 times
ametsopnafets
Posts: 2

Re: FlyTampa Amsterdam and ORBX Netherlands city autogen

Post by ametsopnafets » Wed Sep 12, 2018 4:56 am

Go to the ORBX forum and search for: Netherlands TrueEarth + FT EHAM. In that thread follow Holger Sandmann's instructions. When you do that, everyting is working like it should!
Scupper
Posts: 3

Re: FlyTampa Amsterdam and ORBX Netherlands city autogen

Post by Scupper » Mon Dec 24, 2018 2:03 am

Many thanks. I had the same problem and that fixed it for me.
Christopher Low
Posts: 25

Re: FlyTampa Amsterdam and ORBX Netherlands city autogen

Post by Christopher Low » Sat Jan 26, 2019 11:44 am

The problem with Holger's instructions is that it removes the much more detailed FlyTampa area directly adjacent to the airport, and also adds autogen trees that cover some of the roads and flyovers near the terminals. That is unacceptable to me, so I have compromised to a certain extent. I have followed some of Holger's instructions, so I will need to check out the area that you mention....
Er!k
Posts: 284

Re: FlyTampa Amsterdam and ORBX Netherlands city autogen

Post by Er!k » Sun Jan 27, 2019 3:04 am

Next to that, there seems to be a memory leak somewhere when using FT EHAM and ORBX NL together… I ended up in uninstalling ORBX NL :(
Post Reply