Elevation problem in V5

Post Reply
Dolly77
Posts: 2

Elevation problem in V5

Post by Dolly77 » Thu Apr 30, 2020 5:48 pm

Hello,

I have installed YSSY in P3D v5 but I have some elevation problem as you ca see belowd
2020-5-1_0-32-11-433_LI.jpg
2020-5-1_0-32-11-433_LI.jpg (836.17 KiB) Viewed 419 times
.

I'm using ORBX Australia and FS Global Mesh 2020


Can you help me with this please?
george[flytampa]
Site Admin
Posts: 3385

Re: Elevation problem in V5

Post by george[flytampa] » Thu Apr 30, 2020 10:55 pm

I can't see anything wrong other than two windsocks. Check you don't have another afcad running.

The mesh resolution is best set to 5m if you are seeing drawing order issues where the land meets the water.
Elliot Negrón
Posts: 28

Re: Elevation problem in V5

Post by Elliot Negrón » Sun May 03, 2020 5:40 am

Are you using ORBX Australia v2 or the original ORBX Australia? The original is not compatible with Prepar3d v5 and will cause problems with Prepar3d v5's new scenery elevations.
Dolly77
Posts: 2

Re: Elevation problem in V5

Post by Dolly77 » Mon May 04, 2020 4:34 pm

Elliot Negrón wrote:
Sun May 03, 2020 5:40 am
Are you using ORBX Australia v2 or the original ORBX Australia? The original is not compatible with Prepar3d v5 and will cause problems with Prepar3d v5's new scenery elevations.
I'm using V2 but finally its not a bug it's just me who never noticed that there was a straight wall ...I thought that all the runway surrounding the sea was like the bottom of 34L.

Thank you for your help. I have another problem (real this time) due to the LC but I will open a new thread.
Elliot Negrón
Posts: 28

Re: Elevation problem in V5

Post by Elliot Negrón » Tue May 05, 2020 6:34 am

Dolly77 wrote:
Mon May 04, 2020 4:34 pm
Elliot Negrón wrote:
Sun May 03, 2020 5:40 am
Are you using ORBX Australia v2 or the original ORBX Australia? The original is not compatible with Prepar3d v5 and will cause problems with Prepar3d v5's new scenery elevations.
I'm using V2 but finally its not a bug it's just me who never noticed that there was a straight wall ...I thought that all the runway surrounding the sea was like the bottom of 34L.

Thank you for your help. I have another problem (real this time) due to the LC but I will open a new thread.
According to the ORBX Australia v2 manual, if you are running ORBX Australia v2 in conjunction with FlyTampa Sydney YSSY you need to disable the FlyTampa Sydney LC entry in your scenery library:

https://orbx-user-guides.storage.google ... b9e626.pdf
FlyTampa Sydney
If you have this airport add-on installed please deactivate its “Fly Tampa-Sydney_LC" entry in
your scenery library menu. This will prevent the incompatible (and unneeded) landclass file from
placing randomly changing ground textures in the airport's vicinity
Post Reply