Board index » FlyTampa » FlyTampa-Copenhagen

Post
 Morten (Fri Nov 03, 2017 10:07 pm)

Posts: 5
Hi there

Would it be possible for you to make a fix that actually works for the apron spots, once and for all?
The attached screenshots shows 2 versions of your previous flytampa_ekch_apronSpot.fx files which didn't do the job.

Cheers, Morten
P3D v4
flytampa_ekch_apronSpot_B.JPG
flytampa_ekch_apronSpot_B.JPG (55.64 KiB) Viewed 1801 times
flytampa_ekch_apronSpot_A.JPG
flytampa_ekch_apronSpot_A.JPG (50.84 KiB) Viewed 1801 times
Post
 Morten (Wed Nov 08, 2017 4:18 pm)

Posts: 5
Any help on the subject, please?!
Post
 emilios[flytampa] (Fri Nov 10, 2017 5:08 pm)

Site Admin | Posts: 742 | Location: London, UK
Please try the attached .zip and extract the file into P3D\effects\..
and replace when asked; should be working in the right direction now :)
flytampa_ekch_apronSpot.zip
(838 Bytes) Downloaded 214 times
Post
 Penz (Sun Nov 12, 2017 10:46 am)

Posts: 17
That effect from the ZIP worked here, thank you Emilios. :)
Post
 Morten (Mon Nov 13, 2017 6:18 pm)

Posts: 5
YES, YES, YES!!!
FINALLY! That did it!
All your great work and effort on this airport deserve it!! :D

Cheers,
Morten
Post
 GSCNUUK (Thu Nov 23, 2017 5:38 pm)

Posts: 16
i tryied download the File
and now my apron is pointing down the opposit direction
before it was pointing up the opposit direction

thsi issue is still not solved, what is the cause of this issue
Post
 Morten (Thu Apr 26, 2018 4:52 pm)

Posts: 5
Hmmmm...yeah. After updating from P3Dv4.1 to P3Dv4.2 several of your airports spots gone wild again, including Copenhagen!
Any cure?

Cheers, Morten
Post
 Sethos (Wed May 02, 2018 6:29 am)

Posts: 4
I just installed EKCH fresh and the spots are working perfectly under 4.2, so I assume you need to revert back to the file before you applied the above fix or re-install the airport. Or, with permission, I (or emilios) can post the original file.
Post
 emilios[flytampa] (Fri May 04, 2018 7:51 pm)

Site Admin | Posts: 742 | Location: London, UK
Attaching original .fx file here. goes into P3Droot\effects\ and replace
remember to backup previous file -you never know which version this will work with again :)
flytampa_ekch_apronSpot.zip
(834 Bytes) Downloaded 59 times
Post
 Morten (Sat May 05, 2018 6:04 pm)

Posts: 5
Ha, ha, ha...
Yes! that did the trick!
Through all kinds of problems and fixes and then ending up with the original file back from 2014 for future use - that is funny!

Thank you guys for always being with us!!