Dubai 2.4 ground visible through taxiway

Post Reply
Nepomuk
Posts: 13

Dubai 2.4 ground visible through taxiway

Post by Nepomuk » Sat Nov 14, 2015 6:00 am

Hello Flytampa!
Using P3DV4 and Dubai 2.4 i notice at some locations i experience a layer problem. I´ve had the same issue with P3D2.4 and Dubai 2.3:
omdb1.jpg
omdb1.jpg (84.72 KiB) Viewed 2629 times
The issue is only visible when viewing in a flat angle:
omdb2.jpg
omdb2.jpg (86.42 KiB) Viewed 2629 times
At some location the taxiway lines got overlayed:
omdb3.jpg
omdb3.jpg (114.23 KiB) Viewed 2629 times
I disabled the Mesh, vector and the LC, but without success.


Addons:
Mesh FS Global 2010,ORBX Global Base, ORBX Global Vector, ORBX LC EU
Nepomuk
Posts: 13

Re: Dubai 2.4 ground visible through taxiway

Post by Nepomuk » Wed Nov 18, 2015 12:55 pm

Hello!
Is there noone to confirm this problem or is there anything missing int the problem description?

Regards
Stephan
martin[flytampa]
Site Admin
Posts: 5164

Re: Dubai 2.4 ground visible through taxiway

Post by martin[flytampa] » Wed Nov 18, 2015 2:19 pm

I have not seen or had this problem reported before sorry. It must be some incompatibility.
Nepomuk
Posts: 13

Re: Dubai 2.4 ground visible through taxiway

Post by Nepomuk » Thu Nov 19, 2015 3:22 pm

Hello Martin!
I disabled all 3rd pary scenery except Dubai and the issue is still there. I would appreciate if you could check the scenery near taxiway M7 on your setup.
If you don´t see the issue i will make a complete clean P3DV3 installation.

Regards
Stephan
martin[flytampa]
Site Admin
Posts: 5164

Re: Dubai 2.4 ground visible through taxiway

Post by martin[flytampa] » Thu Nov 19, 2015 3:41 pm

Saw it now, only in this particular spot by M7, nowhere else Very odd oval shaped area that flickers, no idea what may cause it. Will post a fix if I can figure it out.
Nepomuk
Posts: 13

Re: Dubai 2.4 ground visible through taxiway

Post by Nepomuk » Sat Feb 27, 2016 4:50 am

Any news on this topic?
I experience the same issue at Vienna and Copenhagen. May it be related to P3D?

Regards
Nepo
Post Reply