A way to configure SABA v1.9, P3D v4

Post Reply
NeilR1986
Posts: 1

A way to configure SABA v1.9, P3D v4

Post by NeilR1986 » Thu Jun 21, 2018 5:31 am

Hi, I was just wondering if there is a way to configure this airport, like removing the people/grass/windsocks etc as the settings in the configurator don't seem to change anything for SABA.

The reason being is I don't have a powerful system, and I'm having lower frames at SABA compared to TFFJ and TNCM, about 10-15 frames less. Around the other two I get 35-40, so I'd like to adjust SABA to try and get the frames up a little bit if I can :)
martin[flytampa]
Site Admin
Posts: 5190

Re: A way to configure SABA v1.9, P3D v4

Post by martin[flytampa] » Mon Jun 25, 2018 11:14 pm

You can rename BGL files to BAK or OFF in FlyTampa/Saba/scenery/. They are named in a way you should be able to figure them out.
Post Reply