St. Maarten complete & Ftx VECTOR products

Post Reply
Yann
Posts: 9

St. Maarten complete & Ftx VECTOR products

Post by Yann » Fri Jun 08, 2018 2:11 pm

I warn you that I'm french, do not be surprised if my english is bad

So , I have a problem with the compatibility between fly tampa St.Maarten and Ftx Vector, in fact, all around the island, the mesh is problematic ( as shown in the photo attached)
mesh problem
mesh problem
Capture d’écran (785).png (2.67 MiB) Viewed 1658 times
In order to solve the problem, I decided to delete the "mesh.bgl" file and all malformations around the island have disappeared with the exception of a new problem appeared. In the southwest of the island, a bug in the mountains was created (photo 2 attached), I discovered that it was the file "mesh.bgl" of Fly Tampa St.barths. So st.barth acts on St Maarten.
southwest island - bug mountains
southwest island - bug mountains
Capture d’écran (767).png (2.39 MiB) Viewed 1658 times
more, houses are rise up
more, houses are rise up
Capture d’écran (768).png (2.33 MiB) Viewed 1658 times
Also, some islands between St.Maarten and St.Barths have display problems and some minimal problems between the mesh and the terrain in TFFJ in St.barths. In Saba, not really a visible problem just a double view from the control tower

I think that this problem will never be solved because it would require the collaboration between orbx and fly tampa but I would like so much that there is an update download patch for those who have Vector.
Yann
Posts: 9

Re: St. Maarten complete & Ftx VECTOR products

Post by Yann » Sat Jun 23, 2018 11:40 am

Finally I decided to remove FTX VECTOR from my P3D (where I use FLY TAMPA) and I keep it for FSX. So this problem does not matter now. (I repeat if my english is bad I'm french.)
Post Reply