A different problem at SABA, V1.9

Post Reply
jalbino59
Posts: 2

A different problem at SABA, V1.9

Post by jalbino59 » Wed May 30, 2018 10:29 am

I have installed using the individual installers for each TNCM, TFFJ, and SABA.

Everything is fine with just this one issue. When I load a flight starting at SABA on the active runway, the scenery is perfect.
If I taxi the aircraft to a parking location, it's still fine

However, if I load a flight starting at one of the parking locations, The issue with the scenery floating above the AC location returns.

Do you have any advice for me?
martin[flytampa]
Site Admin
Posts: 5175

Re: A different problem at SABA, V1.9

Post by martin[flytampa] » Wed May 30, 2018 11:31 pm

I just tested both "parking 1 and gate 5", had no problem starting at either of them with stock p3d f22.

Usually the only reason for wrong elevation must be Afcad/ADE related.

You can check that you have P3D/FlyTampa/Saba/World/scenery/SABA_ADE4_FLYTAMPA_dummy.BGL
and that this folder is declared in the P3D/FlyTampa/Saba/add-on.xml

<AddOn.Component>
<Category>Texture</Category>
<Path>texture</Path>
<Type>WORLD</Type>
</AddOn.Component>

Other then that my only other idea is to search your installation for other Afcad files for SABA.
jalbino59
Posts: 2

Re: A different problem at SABA, V1.9

Post by jalbino59 » Thu May 31, 2018 6:34 am

Thanks, this information gives me a better idea as to what to do.

Regards,
Jose
Post Reply